You need a phillips precision screwdriver to remove it, but make sure it is the exact right size or you will strip the screw. This is the part that is most difficult about this procedure because that screw can be VERY difficult to remove. This housing is held on by a single precision screw found at the base. Once you have the assembly unfastened, you will see that the stylus light is within a silver housing. Once it is unscrewed light the stylus assembly up and out, then flip it over. First unscrew the assembly from the turntable housing. The stylus light assembly is located nearly straight center bottom of the turntable. Carefully pull the rubber base from the bottom of the turntable. Once they are removed you will notice there is another screw under each one. The foot pads come off by turning them counter clockwise. Flip it over and remove the 20 sum screws from the underside and remove the foot pads. Always unplug your turntable before removing the platter. I could not find a 20VDC bulb so I used a 12VDC bulb and it seems to be working fine, and the bonus is it is a little brighter!!įirst remove the platter, secure the tonearm, and remove the 45 plug from your turntable. Can be found at most electronics stores or can be ordered online. #2 Phillips Screwdriver, Precision Screwdriver set, Soldering Iron, Solder wick, Solder. First of all, getting the light housing off is tricky, and second, they actual stylus light bulb has to be soldered back in place. Unfortunately Technics did not make this an easy process. Replacing the Stylus Light on the Technics 1200
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |